New AutoPOL version 03.33.0030

2023-10-31

A new updated version 03.33.0030 of AutoPOL has been released. This version includes new functionality and a few minor improvements/fixes. The major ones are briefly described below.

Customers with an active Subscription can download this version from the AutoPOL Portal.
Do not forget to back-up your AutoPOL Common Files on a regular basis.

General

  • Support for new 3D file versions added
    The currently supported versions can always be found on www.autopol.com/translators, but the new versions added in this release are the following.

    NX: 2306
    Creo: 10
    Inventor: 2024

BendSIM

  • First Bend Markers
    This is a simple, but great, new feature that allows inserting symbols to show exactly how to position the part for the first bend.
    By engraving those symbols at the first bend, the operator can clearly see what side to put towards the back gauge fingers and if the bend goes up or down. This helps avoiding operator mistakes and thus minimizing initial scrap parts.
    This feature is enabled in the DXF settings when exporting the flat pattern.

  • Support for Murata MOS controls
    We are happy to announce that from this version, AutoPOL supports the Murata MOS control.
    This enables the use of AutoPOL together with press brakes from the Japanese manufacturer Murata.

  • Support for Schiavi Titano controls
    Another new control that is now supported is the one called Titano from Schiavi.

  • Support for Durma DT10/DT15 controls
    Two additional controls, called DT10 and DT15, from Durma are now also supported.

<